10 TOP Process Equipment And Plant Design Objective type Questions and Answers pdf

1. Pick out the wrong statement

2. The distance between the centre of a rivet hole to the nearest edge of the plate is called

3. Tubes are fixed to the tube sheet (a thick circular metallic plate) by the method of tube rolling and brazing (non-removable) or ferrule connection (removable). Thickness of the tube, sheet is normally ________ the outside diameter of the tube but in no case it should be less than 22 mm (7/8”)

4. Wind load consideration in the design of a support can be neglected, when the vessel is

5. A shell may by termed as thin if its thickness to diameter ratio is less than 0.1. The factor which can be neglected in the calculation of membrane stresses is

6. Frame thickness in the plate and frame filter press is normally in the range of _________ inches.
7. In a pressure vessel containing multiple openings of various dimensions at different parts, stress concentration at the edges of the opening is maximum which becomes negligibly small beyond the area covered by _________________ times the hole diameter
8. A minimum clearance of about __________________ mm is maintained between the distillation column wall and the bubble cap
9. Cvlinderical shell thickness of rotary drier is generally ________________ mm

10. Which of the following efficiencies can be greater than 100%?